Skip to main content
Link My Gear
← Back to home

Last Updated: July 30, 2026

Document version 2026-07-30

Regulatory compliance

Link My Gear Airguard (Link My Gear Tracker, hardware rev 54).

This page is the electronic label for the device, published under 47 CFR §15.19.

Responsible party

Link My Gear Inc. 254 Chapman Rd, Ste 208 #22154, Newark, DE 19702, USA certification@linkmygear.com

United States (FCC)

The device complies with 47 CFR Part 15, Subpart B (unintentional radiator) under a Supplier's Declaration of Conformity. Its radios operate under the existing grants of the integrated modules, within their granted conditions.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Contains FCC ID: 2ANPO00NRF9151 — Nordic Semiconductor nRF9151 (LTE-M / NB-IoT)

Contains FCC ID: YCP-32WB5MMGH02 — STMicroelectronics STM32WB5MMG rev X (Bluetooth LE)

Changes or modifications not expressly approved by Link My Gear Inc. could void the user's authority to operate the equipment.

Class B digital device (§15.105(b))

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Canada (ISED)

The device complies with ICES-003 (Class B digital apparatus). Its radios operate under the modules' ISED certifications.

Contains IC: 24529-NRF9151

Contains IC: 8976A-32WB5MMGH02

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF exposure

To comply with FCC and ISED RF exposure requirements, this device and its antenna must be operated with a minimum separation distance of 20 cm between the radiating cellular element and all persons during cellular transmission. The device is designed so that cellular transmission occurs only when the device is detached from the body.

Testing

EMC and radio testing performed by Nemko Canada Inc. — reports REP174694 (FCC 47 CFR Part 15 Subpart B / ICES-003) and REP174695 (host integration, Bluetooth LE and LTE).